|
aHR0cDovL2ZyZWVzaGlwLmNvLmty
- ±Ù¿ø: CN (Á¤Ç°)
- Áõ¸í¼: FCC
¿É¼ÇÁ¤º¸[(175)Green]
1. Voltage range 9~24V, large load current 10A (for 30 seconds), 7A (for a long time), 10A fuse 2. Potentiometer/0~5V analog signal and TTL level/-5V~+5V differential analog signal or RS485 various input signals 3. PWM speed regulation (voltage regulation), torque control (steady current), closed-loop speed regulation (steady speed) of self-testing speed/external tachometer generator (steady speed) 4. PID adjustment of motor current, configurable for large load/braking current, short start/brake/commutation time and small impact force 5. Forward and reverse bidirectional speed regulation, the forward/reverse speed can be preset and stored, and the start, stop and direction can be controlled by switches/buttons
6. Two limit switches can be connected to the forward and reverse limit 7. Motor overload and stall current limit, prevent overcurrent from damaging the motor, support stall limit stop 8. Support RS485 multi-site communication, support MODBUS-RTU protocol, facilitate control of various controllers (such as single-chip, PC or PLC), support communication interruption and stop protection 9. 18kHz PWM frequency, motor speed regulation without PWM clamor 10. Very small PWM dead zone, only 0.5us, PWM effective range 0.1%~999% 11. All interfaces are ESD protected, which can adapt to complex on-site environment Product name: DC motor driver Model: AQMD2410NS Voltage range: 9-24V Rated current: 7A Maximum current: 10A Control signal: potentiometer, analog quantity, switch, 485 Speed regulation mode: duty cycle, closed-loop speed regulation, short force control Applicable motor: DC brush motor Maximum matching motor: 24V-120W, 12V-40W Product size: 5.5X5.5X3cm Colour:green Material:PCB+Metal
Package Contents: 1 x DC motor driver
Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
|
|
|
|
|