2.8”TFT Latest Version NanoVNA-H Upgrade Antenna Vector Network Antenna Analyzer MF HF VHF UHF Spectrum Analyzer SD Card Slot
Introduction:
This is a DIY product that provides as complete a vector network measurement function as possible in terms of credit card size. It includes a 2.8 inch touch screen, a 400mAh battery, and TX/RX measurement, which can measure complete S11 and S21 parameters. If S12 and S22 need to be obtained, manual replacement of the transceiver port wiring is required.
NanoVNA-H PCB Upgraded Version:
1. Lower power noise, lower noise when using harmonics.
2. Built in 400mAh battery.
3. Add MicroSD slot to facilitate the storage of test data.
4. Supports RTC.
5. Modify the port name to Port 1 and Port 2.
6. MicroSD supports maximum 32GB SD card.
7. Only supports SPI mode.
Specifications:
¡Ü Measurement frequency: 50KHz~1.5GHz
¡Ü RF output: -13dbm (-9dbm)
¡Ü Frequency accuracy:<2ppm
¡Ü Frequency stability:<0.5ppm
¡Ü Measurement range: ¡Ü Measurement range: 70dB (50kHz 300 MHz), (50dB (300M-900MHz), 40dB (900M-1500MHz));
¡Ü Port SWR:< 1.1
¡Ü Display: 2.8 inch TFT (320 x240)
¡Ü USB interface: USB type-C communication mode: CDC (serial)
¡Ü Power supply: USB 5V 120mA, built-in 400mAh battery, charging current 1A, can be used continuously for more than 4 hours
¡Ü Number of calibration points: 101 (fixed)
¡Ü Number of scanning points: 101 (fixed)
¡Ü Display Tracking: 4, Mark: 4, Set Save: 5
Packing List:
1. NanoVNA host * 1 (including a 2.8-inch touch screen and 400mAh battery)
2. 20cm SMA male to male RG174 RF cable * 2
3. Type-C to Type-C connection cable
4. USB Type-C data cable * 1
5. Simple instructions * 1
6. Touch Pen * 1
7. Paddle * 1
8. SMA Simple Calibration Kit Load * 1
9. SMA Simple Calibration Kit OPEN * 1
10. SMA Simple Calibration Kit SHORT * 1
11. SMA female to female connector * 1
12. Packaging size: 12 * 9.5 * 3.5cm
13. Packaging weight: 180g