|
aHR0cDovL2ZyZWVzaGlwLmNvLmty
- Àü±¸ Æ÷ÇÔ: ±×·¸½À´Ï´Ù
- ºê·£µå À̸§: BRIDAY
- »ç¿ë¹ý: Industrial
Ç÷¹À̽º Ȧ´õ The strong ultraviolet high pressure mercury lamp (uv lamp) supplied by our company is a lamp housing made of pure quartz glass with a very high violet transmission rate. When the lamp is in operation, the ultraviolet radiation wavelength is 365nm, which is suitable for ultraviolet curing machines and various In UV curing light boxes, it is widely used in the curing of photosensitive solder resist on printed circuit boards, curing of photosensitive character inks, photosensitive iron printing inks, and curing of PVC plastic decorative board printing inks, curing of wooden floor photosensitive resin UV paint coatings, soft packaging color printing, and plastic bottles. The photosensitive inks, photosensitive paints and photosensitive resins on the cover and various workpieces cure high-quality light sources. The lamp has high intensity of ultraviolet light radiation, long life, fast curing speed for various photosensitive materials, no pollution, and is well received by users. Friends in need are welcome to order.
Correct installation and use:
1. Wipe the lamp with ethanol before installation, and then put on clean gloves to hold the lamp.
2. Pass the lamp tube through the cloth pad on the card holder to install the lamp tube hole, do not let the lamp tube touch the metal end plate surface, let the lamp tube pierce through the cloth. UV lamps with wiring directions must pay attention to the direction. Failure to do so will result in lamp damage, reduced life, or overheating of the lamp surface.
3. The lamp tube is installed in place. Hold the lamp holder with your hand and swing it on the card holder to see if the lamp tube is in a free state, so that no cracking will occur when the lamp is installed.
4. Sometimes when inspecting the lamp, remove the UV lamp and observe that there are traces of hand marks on the wall of the lamp, and it can not be wiped off. This is because no gloves were worn when installing the lamp, and the sweat and dirt on the hand stuck to the lamp and sintered on the quartz glass crystal by high-temperature carbonization. Leakage occurs at the spot where the lamp is severed and the lamp is scrapped.
5. Install or replace the UV lamp. You must turn off the power when cleaning the lamp cover. Otherwise, you may get an electric shock.
6. Maintenance of the lamp tube During the period of use of the UV lamp, clean the surface of the lamp tube and the reflector on the surface of the reflector with anhydrous ethanol and gauze at an appropriate time (1 to 2 months), and then rotate the UV lamp tube by 180 ¡Æ C. The reflector of the lampshade should be replaced after losing the mirror effect
7. The restart interval of the UV high pressure lamp is 6 minutes.
8. At the end of the work, the UV lamp is turned off but the temperature of the lamp is still very high. It needs to continue cooling until it reaches room temperature, so the fan must be turned off for a period of time.
9. The fixed point of the ultraviolet high pressure lamp is at the magnetic head, and the end lead cannot be suspended when the ignition point is stressed.
10. Keep the pipe wall clean, especially remove oil stains and dust. Because these substances will penetrate the lamp tube on the surface of the high temperature tube wall, blocking the ultraviolet radiation.
Note: Can be customized according to customer requirements, please contact our sales department directly for details.
|
|
|
|
|